Warning:
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
Click Here To View The Installation PDF
Click Here for the Product Installation Video
Click Here for the Special Instructions Video
RUGER® New and Old Model Blackhawk Super Blackhawk and Bisley No Drill Scope Mount
This mount fits on any length barrel
PLEASE NOTE:
Not compatible with the .45 Colt Caliber or 30 Carbine
This scope mount does not fit Flat Top model RUGER®
This scope mount does not fit Hunter Model RUGER® or 357 Maximum (357 Magnum is OK)
A no drill and tap scope mount for the RUGER® Blackhawk and Super Blackhawk that you can depend on. The rugged two piece construction makes installation a breeze. A billet Aluminum underlug is secured with two Brass set screws to reduce any marring of your barrel surface. Tightening the Allen screws secures the underlug to the barrel as if it were an integral piece of the revolver. The scope mount is then attached to the underlug and rear sight elevation hole for a no drill and tap installation. The revolver rear sights need to be removed for installation. All screws necessary for installation are included. Please take the time to watch the installation video.
The underlug and body are made from 6061-T6 Aluminum. The entire assembly weighs only 2.4 ounces. The underlug is secured with 2, 8-32 Brass Allen set screws for the ultimate in security. The scope mount is attached to the underlug with 2, 6-40 screws and to the revolver with 1, 6-48 screw. The scope mount is 4.5" Long
Click Here To Purchase Allen Wrenches
Click Here To Purchase Replacement Screws
RUGER Blackhawk Super Blackhawk Scope Mount no drill
SKU: SBHNDB, SBHNDS
Product Warnings:
Not compatible with the .45 Colt Caliber or 30 CarbineThis scope mount does not fit Flat Top model RUGER®This scope mount does not fit Hunter Model RUGER® or 357 Maximum (357 Magnum is OK)
Product Materials: 6061-T6
Product Length: 4.5"
Product Height: .410 from top of the receiver
Product Weight: 2.4oz
Screws Included:
2) 6-40x5/16 Allen head cap screws
Allen wrench size required is 7/64
Torque setting 11 inch pounds
1) 6-48x3/8 Allen head cap screw
Allen wrench size required is 3/32
Torque setting 13 inch pounds
2) 8-32x1/4 Brass set screws
Allen wench size required is 1/16
Tighten until touching the barrel